[click] R 23 TREAD BUILDER

Builds pre-cure and die stock Builds tires from 21.5 outside diameter to 52" outside diameter Automatically cuts rubber to the proper length Expanding chuck assembly Contoured stitcher/drive roller Carbide blade cuts rubber and texturizes ends at the same time Safety engineered Full cap stitcher (optional) Line light (optional) Powered by air and 115 VAC current Here's a close-up shot of the control panel for the R 23 Tread Builder OUTSTANDING PERFORMANCE The R-23 Tread Builder was designed for the production shops. It applies the cushion gum and the tread rubber separately to the tire. This requires the operator to make two applications to the tire allowing him to find nail holes in the casing prior to applying the tread rubber. The tread cutter has been designed to cut the tread to the proper length. As the tread rubber is cut, the carbide coated cutter blade texturizes the butt ends of the rubber so that it is ready to be spliced. The cutter is operated with an air over air system so that the cutter operates smoothly without jerks or lunges. This system uses no oil and eliminates the possibility of contamination of the tread and the mess usually associated with air over oil systems. With the optional secondary stitcher the R-23 is capable of building full cap die stock rubber. The R-23 Tread Builder operates mainly on compressed air using 115 volts AC current to operate the solenoid valves and the cutter motor. Air motors are used to eliminate drift when stopped. This provides a high degree of accuracy when measuring the tread rubber length. Cushioned air cylinders are used, where necessary, to protect the cylinders and component from damage when traveling to their limits with no load. Most machined components are manufactured on the latest computer numerical control equipment to guarantee accuracy and repeatability in machinery. Due to our policy of continuous product improvement, there may be some differences in appearance and specification from those referred to in the above material. Cahill Manufacturing Co., Inc. would like to thank you for your interest in our products. If we may answer any question you have regarding our equipment, please do not hesitate to call on us.

[click]

Builds pre-cure and die stock Builds tires from 21.5 outside diameter to 52" outside diameter Automatically cuts rubber to the proper length Expanding chuck assembly Contoured stitcher/drive roller Carbide blade cuts rubber and texturizes ends at the same time Safety engineered Full cap stitcher (optional) Line light (optional) Powered by air and 115 VAC current OUTSTANDING PERFORMANCE The TR-36 Tread Builder was designed for the high production shops. It applies the cushion gum to the tread rubber prior to being applied to the tire. This allows the operator to make one application to the tire instead of two, eliminating one step in the operation. The tread cutter has been positioned so that it cuts the tread rubber before the cushion is applied thereby eliminating waste when new rolls of rubber are spliced. The cutter is operated with an air over air system so that the cutter operates smoothly without jerks or lunges. This system uses no oil and eliminates the possibility of contamination of the tread and the mess usually associated with air over oil systems. With the optional secondary stitcher the TR-36 is capable of building full cap die stock rubber. The TR-36 Tread Builder operates mainly on compressed air using 115 volts AC current to operate the solenoid valves and the cutter motor. Air motors are used to eliminate drift when stopped. This provides a high degree of accuracy when measuring the tread rubber length. Cushioned air cylinders are used, where necessary, to protect the cylinders and component from damage when traveling to their limits with no load. Most machined components are manufactured on the latest computer numerical control equipment to guarantee accuracy and repeatability in machinery. Due to our policy of continuous product improvement, there may be some differences in appearance and specification from those referred to in the above material. Cahill Manufacturing Co., Inc. would like to thank you for your interest in our products. If we may answer any question you have regarding our equipment, please do not hesitate to call on us.